From: Stephens, A. <all...@wi...> - 2005-12-20 13:53:20
|
Hi Vishal: =20 Currently TIPC does not allow you to change the netid (or the node address) once the node address has been set. The ability to make such changes was removed in TIPC 1.5 because it did not work reliably, and because it was felt that most users did not require the capability of changing these values on-the-fly. =20 Regrads, Al ________________________________ From: tip...@li... [mailto:tip...@li...] On Behalf Of Vishal Soni-G20083 Sent: Tuesday, December 20, 2005 2:31 AM To: tip...@li... Subject: [tipc-discussion] Question regarding netid configuration =09 =09 Hi all, =20 I am not able to Re-configure netid even after disabling bearer. Is there any specific reason why this is not allowed?=20 =20 To configure another netid I have to remove and insert module again. =20 Vishal Soni. Motorola. =20 |