Console command line use.

Serial Bootloader for Microchip, Atmel, NXP, TI, 8051 microcontrolers

Status: Beta

Brought to you by: edorul, evanvennn

Console command line use.

Forum: General Discussion

Creator: Graham

Created: 2021-06-17

Updated: 2021-06-17

Graham - 2021-06-17

Hi...
I think the pc program can be driven as command line without invoking the GUI? Is there a ref to the supported commands for that - I looked, can't see it but may well have missed it!
Thanks...

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Anobium - 2021-06-17

Oh yes.

"%FileName%" exit

Replace %FileName% with the complete filename.

Last edit: Anobium 2021-06-17

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Graham - 2021-06-17

Right... Simples! Rest of setting are from config.in then, presumably.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- Anobium - 2021-06-17
  
  Yes. You MUST run the GUI exe once to set up the ports etc.
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.