Re: [swanmodel-users] Netcdf error while computing

[Sander H. <san...@bm...>]

Hi,

https://sourceforge.net/p/swanmodel/mailman/message/35316702 holds the
solution. Note that you are required to modify and recompile the model.

With best regards,
Sander

On 12/13/2016 11:48 AM, Murali Kallungal wrote:
>  Hi Swan users,
> We are new to this community.
> While adding DISM to the output function swan make netcdf error, but mat
> format is working
> Kindly help us to solve this issue, error is posted below
> 
> 
>  FRAME 'mud' 75.5 8.4 0 2 2 200 200
>    
>  BLOCK 'COMPGRID' NOHEADER 'output.nc <http://output.nc>' LAY 3 HS DIR
> TM01 DISM OUT 20150101.000000 1 HR
>  ** Error            : netCDF output not allowed for output.nc
> <http://output.nc>
>    
>  COMPUTE 20150101.000000 10 MIN 20150101.120000
>  ** No start of computation because of error level:  2
>  ** To ignore this error, change [maxerr] with the SET command
>    
>  $COMPUTE
>    
>  $
>    
>  STOPtput.nc
> 
> -- 
> -------------------------------
> 
> *Muraleedharan K.R*
> -------------------------------
> *Scientist *
> /National Institute of Oceanography
> Regional Centre
> Salim Ali Road
> P.B. No. 1913/
> /Kochi - 682 018
> Kerala, India
> Ph (O): +91-484-2390306
> Fax:     +91-484-2390618
> Mob:    +91 9495254557
> _E-mail: mur...@ni... <mailto:mur...@ni...>_/
> 
> ______________________________________________________________________
> This email has been scanned by the Symantec Email Security.cloud service.
> For more information please visit http://www.symanteccloud.com
> ______________________________________________________________________
> 
> 
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most 
> engaging tech sites, SlashDot.org! http://sdm.link/slashdot
> 
> 
> 
> _______________________________________________
> swanmodel-users mailing list
> swa...@li...
> https://lists.sourceforge.net/lists/listinfo/swanmodel-users
>