Re: [swanmodel-users] Problems when using Battri matlab code calling triangle mesh generator

[Ahmad K. (Student) <ah...@ma...>]

Hello Haibo,

You will need the Opnml toolbox too, the link for that is available somewere on sourceforge, both should be added to toolbox path, you can check how on mathworks. If you are using windows, you will need the cywing1.dll extension to run triangle.
However, I couldn't run these two toolboxes untill I have made several changes in the scripts, because some of the used matlab functions were outdated. I have added a waiting bar inside tsearchsafe.m too so I will now how much to wait.. Interpolation may take too long to run.
If you are interrested I can send you my adjusted scripts.

Regards, Ahmad

Sent from my iPhone

> On 6 Jun 2016, at 18:23, "Haibo Xu" <hai...@up...> wrote:
> 
> Hi all,
> 
> I am using Battri matlab code calling trangle mesh generator which is C languiage. How Can I do that, like how to add path properly. Did someone use the same way to generate 2D mesh with respect to bathmetry?
> 
> Thanks.
> 
> Haibo
> ------------------------------------------------------------------------------
> What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
> patterns at an interface-level. Reveals which users, apps, and protocols are 
> consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
> J-Flow, sFlow and other flows. Make informed decisions using capacity 
> planning reports. https://ad.doubleclick.net/ddm/clk/305295220;132659582;e
> _______________________________________________
> swanmodel-users mailing list
> swa...@li...
> https://lists.sourceforge.net/lists/listinfo/swanmodel-users