how to load two disks with command line ?

An update of legendary Atari ST emulator Steem

Brought to you by: steven-seagal

how to load two disks with command line ?

Forum: Steem SSE Bug Reports

Created: 2024-01-25

Updated: 2024-01-26

lp69 - 2024-01-25

Hi !
The doc says "If two disks are passed, then the first will go in drive A and the second will be in drive B. "
But I have tried everything possible, and only one disk is loaded.
I need to load two disks and one snapshot in the command line. How to ?
Thanks for the great software !
Laurent

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

STeven - 2024-01-26

Hi Laurent,
Sorry, can't reproduce.

For instance, with the command line

D:\Emu\ST\bin\steem\Steem32D3D.exe "D:\Emu\ST\bin\steem\memory snapshots\ec.sts" "D:\Emu\ST\Testpack\HFE Disk - Copy.HFE" "D:\Emu\ST\Testpack\FROGGY_1.DIM"

the snapshot loads and even though only drive A had a disk when the snapshot was saved, both images get in A and B, also if drive B is disabled.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

lp69 - 2024-01-26

Thanks for your answer ! I thought I had tried everything possible, but looking at your example, I didn't !
So I put the snapshot first in the command line before the disks, and... it worked !

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.