[sparta-users] Surface mesh units

[Zuheyr A. <zuh...@vk...>]

Dear colleagues, Sparta Developers,

I normally always work with CAD models in meters. But this time I have surface mesh in milimeters.

In the read_surf command I can specify 3 scales Sx,Sy,Sz as 0.001, 0.001, and 0.001. Then continue as if the mesh is in meters.
Am I right? To get Sparta run on a 3D model is always a big struggle for me, I just want to be sure if I am right. As I usually need to struggle to get Sparta run on complex 3D surface models.

Thank you for reading.

Best regards,
Zuheyr


Dr. Zuheyr Alsalihi
Senior Research Eng.
von Karman Institute
72, Chee. de Waterloo
1640 Rhode-St-Genese, Belgium.
+32 359 98 65