Menu
▾
▴
#143 Wii Won't Boot with SNEEK+DI Installed
New
nobody
None
2011-09-27
2011-09-24
Anonymous
No
Originally created by: sahariel...@gmail.com
What steps will reproduce the problem?
1. Use ModMii to install SNEEK+DI and create an emulated NAND on the Sandisk 32 GB MicroSDHC Card.
2. Plug in Western Digital MyBook 2 TB External Hard Drive to right USB slot in Wii.
3. Boot Wii.
What is the expected output? What do you see instead?
I expected the System Menu to boot after 3-5 minutes as it says in the guide. It's been over an hour and no signal
What revision are you using? With what configuration
(SNEEK/UNEEK/SNEEK+DI)?
SNEEK+DI rev 168
Please provide any additional information below.
The Wii emits a brief flash before going blank when I attempt to boot it. Nothing else happens.
View and moderate all "tickets Discussion" comments posted by this user
Mark all as spam, and block user from posting to "Tickets"
Originally posted by: crazycav...@gmail.com
Have you been able to get SNEEK (without DI) working? If not, this should be your first step. Also, I believe SDHC cards are not supported (could be wrong), so if SNEEK doesn't work, try it with a 2GB non-SDHC card and see if that works.