In the simple circuit of a PNP transistor biasing, the volage at the collector is shown as 2.54 v. At base is shown as 2.56v.Actually it should be 2.63v[15/ (47+10)]x10]. At the emmiter shown as 2.49v. Because it is a PNP,its base emitter junction is reverse biased, hence transistor is cutoff. So at its collector there should be full supply,that is 15v. Am i correct?
To the circuit i connected a source voltage of 15v. From 15v to the base, a 47k, from the base to ground, a 10k, 15v to collector a 1k, emitter to ground, a 220 ohm.
Pl be kind to concentrate on this. A lot of thanks for providing us with this free software. Pl reply at nandasena.agampodi@gmail.com
Base volage is about precission, set non linear precission in circuit properties to 6 and you will get more accurate voltages.
I think i will set to 6 by default...
I will have a look to collector voltage issue.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
In the simple circuit of a PNP transistor biasing, the volage at the collector is shown as 2.54 v. At base is shown as 2.56v.Actually it should be 2.63v[15/ (47+10)]x10]. At the emmiter shown as 2.49v. Because it is a PNP,its base emitter junction is reverse biased, hence transistor is cutoff. So at its collector there should be full supply,that is 15v. Am i correct?
To the circuit i connected a source voltage of 15v. From 15v to the base, a 47k, from the base to ground, a 10k, 15v to collector a 1k, emitter to ground, a 220 ohm.
Pl be kind to concentrate on this. A lot of thanks for providing us with this free software. Pl reply at nandasena.agampodi@gmail.com
Hi. Thanks fro reporting.
Base volage is about precission, set non linear precission in circuit properties to 6 and you will get more accurate voltages.
I think i will set to 6 by default...
I will have a look to collector voltage issue.
Solved in SimulIDE_0.3.10-SR2