[Serial-pci-info] Cyclades Cards
Brought to you by:
tytso
From: Luff Jolan-A. <AJ...@mo...> - 2001-11-07 23:45:37
|
The cards are cyclades 8yo+ pci dmesg --------- PCI: Found IRQ 9 for device 02:0b.0 Redundant entry in serial pci_table. Please send the output of lspci -vv, this message (12b9,1008,12b9,00a2) and the manufacturer and name of serial board or modem board to ser...@li.... ttyS04 at port 0xd000 (irq = 9) is a 16550A PCI: Found IRQ 5 for device 02:0e.0 Redundant entry in serial pci_table. Please send the output of lspci -vv, this message (12b9,1008,12b9,00a2) and the manufacturer and name of serial board or modem board to ser...@li.... lspci -vv ----------- 00:00.0 Host bridge: Intel Corporation: Unknown device 1130 (rev 04) Subsystem: Asustek Computer, Inc.: Unknown device 8027 Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort+ >SERR- <PERR- Latency: 0 Region 0: Memory at f8000000 (32-bit, prefetchable) [size=64M] Capabilities: <available only to root> 00:01.0 PCI bridge: Intel Corporation: Unknown device 1131 (rev 04) (prog-if 00 [Normal decode]) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap- 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 0 Bus: primary=00, secondary=01, subordinate=01, sec-latency=0 Memory behind bridge: f4800000-f5dfffff Prefetchable memory behind bridge: f5f00000-f7ffffff BridgeCtl: Parity- SERR- NoISA- VGA+ MAbort- >Reset- FastB2B- 00:1e.0 PCI bridge: Intel Corporation: Unknown device 244e (rev 02) (prog-if 00 [Normal decode]) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR+ FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 0 Bus: primary=00, secondary=02, subordinate=02, sec-latency=32 I/O behind bridge: 0000b000-0000dfff Memory behind bridge: f1800000-f47fffff Prefetchable memory behind bridge: f5e00000-f5efffff BridgeCtl: Parity- SERR+ NoISA+ VGA- MAbort- >Reset- FastB2B- 00:1f.0 ISA bridge: Intel Corporation: Unknown device 2440 (rev 02) Control: I/O+ Mem+ BusMaster+ SpecCycle+ MemWINV- VGASnoop- ParErr- Step ping- SERR+ FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR- Latency: 0 00:1f.1 IDE interface: Intel Corporation: Unknown device 244b (rev 02) (prog-if 80 [Master]) Subsystem: Asustek Computer, Inc.: Unknown device 8027 Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR- Latency: 0 Region 4: I/O ports at a800 [size=16] 00:1f.3 SMBus: Intel Corporation: Unknown device 2443 (rev 02) Subsystem: Asustek Computer, Inc.: Unknown device 8027 Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR- Interrupt: pin B routed to IRQ 12 Region 4: I/O ports at e800 [size=16] 01:00.0 VGA compatible controller: Matrox Graphics, Inc. MGA G400 AGP (rev 04) ( prog-if 00 [VGA]) Subsystem: Matrox Graphics, Inc. Millennium G400 Dual Head 16Mb Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR- Latency: 64 (4000ns min, 8000ns max), cache line size 08 Interrupt: pin A routed to IRQ 12 Region 0: Memory at f6000000 (32-bit, prefetchable) [size=32M] Region 1: Memory at f5000000 (32-bit, non-prefetchable) [size=16K] Region 2: Memory at f4800000 (32-bit, non-prefetchable) [size=8M] Expansion ROM at f5ff0000 [disabled] [size=64K] Capabilities: <available only to root> 02:09.0 Communication controller: Cyclades Corporation Cyclom_8Y above first meg abyte (rev 01) Subsystem: Cyclades Corporation: Unknown device 0100 Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR- Interrupt: pin A routed to IRQ 10 Region 0: Memory at f4000000 (32-bit, non-prefetchable) [size=128] Region 1: I/O ports at d800 [size=128] Region 2: Memory at f3800000 (32-bit, non-prefetchable) [size=16K] 02:0a.0 Communication controller: Cyclades Corporation Cyclom_8Y above first meg abyte (rev 01) Subsystem: Cyclades Corporation: Unknown device 0100 Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR- Interrupt: pin A routed to IRQ 11 Region 0: Memory at f3000000 (32-bit, non-prefetchable) [size=128] Region 1: I/O ports at d400 [size=128] Region 2: Memory at f2800000 (32-bit, non-prefetchable) [size=16K] 02:0b.0 Serial controller: US Robotics/3Com 56K FaxModem Model 5610 (rev 01) (pr og-if 02 [16550]) Subsystem: US Robotics/3Com USR 56k Internal FAX Modem (Model 2977) Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR- Interrupt: pin A routed to IRQ 9 Region 0: I/O ports at d000 [size=8] Capabilities: <available only to root> 02:0c.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev 78 ) Subsystem: 3Com Corporation 3C905C-TX Fast Etherlink for PC Management N IC Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR- Latency: 32 (2500ns min, 2500ns max), cache line size 08 Interrupt: pin A routed to IRQ 7 Region 0: I/O ports at b800 [size=128] Region 1: Memory at f2000000 (32-bit, non-prefetchable) [size=128] Expansion ROM at <unassigned> [disabled] [size=128K] Capabilities: <available only to root> 02:0d.0 Ethernet controller: 3Com Corporation 3c905C-TX [Fast Etherlink] (rev 78 ) Subsystem: 3Com Corporation 3C905C-TX Fast Etherlink for PC Management N IC Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR- Latency: 32 (2500ns min, 2500ns max), cache line size 08 Interrupt: pin A routed to IRQ 10 Region 0: I/O ports at b400 [size=128] Region 1: Memory at f1800000 (32-bit, non-prefetchable) [size=128] Expansion ROM at <unassigned> [disabled] [size=128K] Capabilities: <available only to root> 02:0e.0 Serial controller: US Robotics/3Com 56K FaxModem Model 5610 (rev 01) (pr og-if 02 [16550]) Subsystem: US Robotics/3Com USR 56k Internal FAX Modem (Model 2977) Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Step ping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort - <MAbort- >SERR- <PERR- Interrupt: pin A routed to IRQ 5 Region 0: I/O ports at b000 [size=8] Capabilities: <available only to root> |