Re: [Scst-devel] QLE2562 target ports not showing up in sysfs

[Rob T. <ro...@rt...>]

On 2/20/2022 7:35 PM, Chesnokov Gleb wrote:
> Hi Rob,
>
>> It's probably just something small that I'm missing, any hints?
> Please check qlini_mode param of qla2xxx_scst module.
>
> cat /sys/module/qla2xxx_scst/parameters/qlini_mode
>
> If it is enabled, this is default mode, than qla2xxx module was loaded in initiator mode.
> You need to load qla2xxx module in target mode,
> so you should manually pass qlini_mode=disabled param during module probing.
>
> modprobe qla2xxx_scst qlini_mode=disabled
>
>
> Thanks,
>
> Gleb.

Spot on Gleb, that did the trick.
On to the next hurdle ;)

Thanks!
Rob