[Sailcut-users] vertical slider in Mould Sail

[Peter L. <pet...@gm...>]

Hi,
During the wintertime I disigned and created a jib for my ship. Last week
my ship went into the water after the winterseason and I had the first
opportunity to try my new sail.
I must say I am happy with theresult.

During the design I came upon an issue which I can't figure out.
In the Sail Mould you can set variables concerning the profile of the sail.
You set the depth and the position of the camber at three levels, top
middle and bottom.
So far pretty clear. On the left side ther is a verticle slider which you
can set the vertical repartition with. Now moving this slider does not have
any influence on the depths of the profile at the tree levels mentioned
earlier. This I don't understand. In my understanding they must be
connected somehow.
Perhaps i misunderstand what is meant by "vertical repartition". As far as
I understand this indicates the position of maximal depth in the vertical
range from bottom to top. Is that right?

I would like to know this. There are more winters to come and my main also
needs replacement.

Thanks in advance,
Peter