Re: [Sailcut-users] Sailcut program - dimension change

[Don B. <do...@si...>]

It would be nice to have additional decimal points added to the calculation screen so you could multiple.  Right now there is only one decimal point unless it is hidden in some other output, so you cannot get an accurate area calculation.

Don's iPhone 

> On Mar 15, 2017, at 11:42 AM, Sheldon Haynie <she...@gm...> wrote:
> 
> Multiplying by 10,000 is too difficult? 
> 
> Sent from my iPhone
> 
>> On Mar 15, 2017, at 8:29 AM, Miroslav <mi...@gm...> wrote:
>> 
>> Hi, I am a RG65 sailing boat racer and constructor. Recently I have stated to use the Sailcut software. It is a nice program and big help to develop the model boat racing sails.
>> As you may know, our RG65 specification limit the sails, jib + main, to the size of 2250 cm2. Now, the Sailcut software calculate the sail surface but it gives it in m2 dimension.
>> Is there any possibility to change the surface dimension to cm2 values and get the precise value? That would help us enormously! 
>> Thanks a lot in advance for your assessment of my matter. 
>> Best regards,
>> Miroslav
>> ------------------------------------------------------------------------------
>> Check out the vibrant tech community on one of the world's most
>> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
>> _______________________________________________
>> Sailcut-users mailing list
>> Sai...@li...
>> https://lists.sourceforge.net/lists/listinfo/sailcut-users
> 
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, Slashdot.org! http://sdm.link/slashdot
> _______________________________________________
> Sailcut-users mailing list
> Sai...@li...
> https://lists.sourceforge.net/lists/listinfo/sailcut-users