Re: [Sailcut-users] (no subject)
Brought to you by:
jeremy_laine,
sailcuter
|
From: Robert L. <rob...@sa...> - 2006-02-11 10:11:35
|
Tomas H=F6rz wrote:
>=20
> Perhaps a copy
>=20
> I got a transfer problem indication
>=20
> Hallo=20
>=20
> I have just opened the new sailcut cad version and so far seems very
> good
> But on a test modell i discovered a problem=20
> When printing gores (panels) the drawing comes with measurment figures
> for short sides overlaping each other so that they eare not pssible to
> read.
>=20
> This only only accurs on the left side of the drawing
>=20
> It seems that on the left side the drawing the lines from the measurmen=
t
> point to the figures all goes in the parallell direction but on the
> right side they point uppwards and downwards thus spredding the figures
>=20
> Best regards=20
>=20
> tomas
>=20
Hello Tomas
Thanks for the feed back.
Would it be possible for you to send me the data file (use
file>save>data menu) such that I can test the printing here.
For this release I tested it with some sails but obviously no the one
giving problems. I will have to add a routine to check that the printing
zone is free.
--=20
Regards / Amiti=E9s
Robert Lain=E9
http://www.sailcut.com Free CAD for sails and hull
http://sailcut.sourceforge.net GPL source code
--
|