[reprap-commits] SF.net SVN: reprap:[4135] trunk/software/host/src/org/reprap/devices/ GenericExtruder.java

[<rhy...@us...>]

Revision: 4135
          http://reprap.svn.sourceforge.net/reprap/?rev=4135&view=rev
Author:   rhys-jones
Date:     2011-05-20 13:41:37 +0000 (Fri, 20 May 2011)

Log Message:
-----------
Fixing percent infill bug

Modified Paths:
--------------
    trunk/software/host/src/org/reprap/devices/GenericExtruder.java

Modified: trunk/software/host/src/org/reprap/devices/GenericExtruder.java
===================================================================
--- trunk/software/host/src/org/reprap/devices/GenericExtruder.java	2011-05-19 11:25:21 UTC (rev 4134)
+++ trunk/software/host/src/org/reprap/devices/GenericExtruder.java	2011-05-20 13:41:37 UTC (rev 4135)
@@ -411,10 +411,7 @@
 			extrusionTemp = Preferences.loadGlobalDouble(prefName + "ExtrusionTemp(C)");
 			extrusionSize = Preferences.loadGlobalDouble(prefName + "ExtrusionSize(mm)");
 			extrusionHeight = Preferences.loadGlobalDouble(prefName + "ExtrusionHeight(mm)");		
-			if (Preferences.loadGlobalDouble(prefName + "ExtrusionInfillWidth(mm)")==-1)
-				extrusionInfillWidth =  extrusionSize/Preferences.loadGlobalDouble(prefName + "ExtrusionPercentInfill(0..1)");
-			else
-				extrusionInfillWidth =  Preferences.loadGlobalDouble(prefName + "ExtrusionInfillWidth(mm)");
+			extrusionInfillWidth =  Preferences.loadGlobalDouble(prefName + "ExtrusionInfillWidth(mm)");
 			lowerFineLayers = 2; //Preferences.loadGlobalInt(prefName + "LowerFineLayers(0...)");
 			upperFineLayers = 2; //Preferences.loadGlobalInt(prefName + "UpperFineLayers(0...)");
 			extrusionBroadWidth = Preferences.loadGlobalDouble(prefName + "ExtrusionBroadWidth(mm)");		


This was sent by the SourceForge.net collaborative development platform, the world's largest Open Source development site.