ClearOS 6.4 is based on CentOS 6.4. I converted a one drive system to RAID 5 using raider. The last stage, raider --run, failed unable to copy the partition table to the fourth disk. I did this manually. Adding the two partitions to the arrays failed because the device was in use. Reboot fixed that. Now syncing.
What steps are needed after installing grub on this drive?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
ClearOS 6.4 is based on CentOS 6.4. I converted a one drive system to RAID 5 using raider. The last stage, raider --run, failed unable to copy the partition table to the fourth disk. I did this manually. Adding the two partitions to the arrays failed because the device was in use. Reboot fixed that. Now syncing.
What steps are needed after installing grub on this drive?