From: Howard D. <ho...@fb...> - 2013-10-15 22:16:06
|
I tried constructing a circuit in QUCS v17 using four copies of my subcircuit. I used the new version of the subcircuit I had constructed under QUCS v16. When I save the circuit and reopen it the subcircuit just disappears in all four locations. I will post the test circuit schematic and the subcircuit schematic on the bug tracker or forum. This is pretty puzzling. It may be related to the bug you noted, but I can't tell. Do you want to see a full circuit? By the way I am using QUCS for a thermal simulation here. The subcircuit is for forced convection. hld Howard L. Davidson Facebook Hardware Engineering 17-3, 1601 Willow Road, Menlo Park, CA 94024 Ho...@fb... 650-906-8849 cell -----Original Message----- From: Guilherme Brondani Torri [mailto:gui...@gm...] Sent: Tuesday, October 15, 2013 9:02 AM To: Howard Davidson; quc...@li... Cc: hl...@sp... Subject: Re: [Qucs-bugs] Subcircuits do not retain rotation when migrating between QUCS versions Hi, On 15/10/13 01:18, Howard Davidson wrote: > I have some moderately complex circuits I developed in v15 that I want to migrate to v16. When I open them in v15 the Subcircuits are all rotated in the same direction as on the enter schematic sheet. If I rotate them correctly to reconnect them, and save the schematic, they are back to the wrong orientation when I open it again. I have tried recreating the subcircuits from scratch, and introducing them into the schematics. This does not help. I will try in v17. > I noticed similar issues, and hopefully they are fixed on 0.0.17. Is your problem related to this bug? https://sourceforge.net/p/qucs/bugs/117/ If you still have problems after upgrading, please provide us with a small schematic which reproduces the issue. Please use the bug tracker or forum, as the mailing list does not accept attachments. Best regards, Guilherme |