[Qucs-help] QUCS weird results.

[Rogier W. <R.E.Wolff@BitWizard.nl>]

Hi, 

I built a circuit yesterday on my breadboard and it didn't work. Then
I decided to run it in the simulator, but it still didn't work. 

Now I don't expect you to help me with my circuit design, but I'm
hoping you'll be able to help me get the simulation running.... 

When I run the simulation, it often tells me the initial DC analysis
of the transistor failed, and then the simulation runs instantly to
0%, 50% or 100% and stops allowing me to hit "abort simulation" but
nothing else. 

Once this works, I'm going to make a voltage reference from a diode
and a resistor, and the transistor is going to be a P-mosfet. 

What's my mistake???

	Roger.

-- 
** R.E.Wolff@BitWizard.nl ** http://www.BitWizard.nl/ ** +31-15-2600998 **
**    Delftechpark 26 2628 XH  Delft, The Netherlands. KVK: 27239233    **
*-- BitWizard writes Linux device drivers for any device you may have! --*
Q: It doesn't work. A: Look buddy, doesn't work is an ambiguous statement. 
Does it sit on the couch all day? Is it unemployed? Please be specific! 
Define 'it' and what it isn't doing. --------- Adapted from lxrbot FAQ