When I rotate a probe, its connections become misaligned with the grid and I'm unable to connect it with wire. Fortunatly, I workaround by "picking" a new probe and rotating it with right click before placing it, but it's very anoying.
Hello,
we know that some components go off-grid when rotated, but do not yet have implemented a solution, also because you can always use "Set on Grid" (Ctrl-U) to properly align the component after rotating it, if needed.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
ouch, the french translation is not enought accurate. "Set on Grid" was translated by "Magnétisme". Usualy, it refers to a "snap to grid" option, and obviously, I wasn't able to make it work .
thanks a lot, this will be very useful.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
we know that some components go off-grid when rotated, but do not yet have implemented a solution, also because you can always use "Set on Grid" (Ctrl-U) to properly align the component after rotating it, if needed.
ouch, the french translation is not enought accurate. "Set on Grid" was translated by "Magnétisme". Usualy, it refers to a "snap to grid" option, and obviously, I wasn't able to make it work .
thanks a lot, this will be very useful.