Qtester104 unable to send command to RTU when command issued from OSHMI

IEC 60870-5-104 protocol tester.

Brought to you by: ricardolo

Qtester104 unable to send command to RTU when command issued from OSHMI

Forum: General Discussion

Creator: Ketil Johannessen

Created: 2020-01-05

Updated: 2020-01-06

Ketil Johannessen - 2020-01-05

Hi!
I have downloaded the OSHMI bundle and setup. Then disabled simulation mode and configured one of the circuit breakers in the KAW screen to route via RTU1. When I try to trip the circuit breaker from ON-> OFF, I see a grey log line of this messsage received by the QTester104, but it does not relay this command to the RTU. I do however see the GI request going to the RTU . Is there some config I have missed out which disables/prohibits the qtester104 protocol driver from actually sending the command to the RTU?

regards,
Ketil

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- ricardolo - 2020-01-06
  
  Hi Ketil,
  Please check your point_list.txt file. For the command point, the RTU column must have the slave address (same value as SECONDARY_ADDRESS parameter from QTester104).
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Ketil Johannessen - 2020-01-06

Thanks!

That did the trick; I am now able to both send commands as well as receive analog measurements in the OSHMI Screen Viewer. Thanks a lot for swift and good response on this.

Last edit: Ketil Johannessen 2020-01-06
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.