When I am in the Airfoil Design section of QBlade, "Edit Foil Coordinates" for one of the air foils imported into QBlade has a problem. As I try to delete or add points, more or less points than what I have selected will either be added or deleted. If I have one point selected to be deleted, it might delete the next ten points even though they are not selected. It's proven to be quite troublesome.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
When I am in the Airfoil Design section of QBlade, "Edit Foil Coordinates" for one of the air foils imported into QBlade has a problem. As I try to delete or add points, more or less points than what I have selected will either be added or deleted. If I have one point selected to be deleted, it might delete the next ten points even though they are not selected. It's proven to be quite troublesome.
Hi,
unfortunately I cannot comment on this issue as the airfoil design module is based on XFLR5 legacy code which I did not code myself.
Best,
David