Good morning David Sir,
Sir, is it possible to get full mass and stiffness matrix from Qblade ?
and as you mentioned in source code " upper triangular matrix (UTM)" which method should i use to transformed on UTM?
Thank you
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
if you have already found the appropriate locations in the source code it should be pretty self-explainatory. We use the EIGEN toolbox to perform all matrix operations in QFEM.
Cheers,
David
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi David Sir
Thank you for helpfull reply ,Sir i have one more question what is meaning of "polyurethane 20 GF 65D " which is used while giving the material property.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Good morning David Sir,
Sir, is it possible to get full mass and stiffness matrix from Qblade ?
and as you mentioned in source code " upper triangular matrix (UTM)" which method should i use to transformed on UTM?
Thank you
Hi Rakesh,
if you have already found the appropriate locations in the source code it should be pretty self-explainatory. We use the EIGEN toolbox to perform all matrix operations in QFEM.
Cheers,
David
Hi David Sir
Thank you for helpfull reply ,Sir i have one more question what is meaning of "polyurethane 20 GF 65D " which is used while giving the material property.