hi,
I would like to set the transport engine of ptpd2 (2.3.1) as ethernet and not ipv4.
In the README file is written that I have to run configure, make, change the parameters in test/client-e2e-socket.conf and make install.
At first I run the daemon with the default configuration, then changed the .conf file but using wireshark the ptp message still has ipv4 and udp frame.
What I'm doing wrong?
Thank you
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
hi,
I would like to set the transport engine of ptpd2 (2.3.1) as ethernet and not ipv4.
In the README file is written that I have to run configure, make, change the parameters in test/client-e2e-socket.conf and make install.
At first I run the daemon with the default configuration, then changed the .conf file but using wireshark the ptp message still has ipv4 and udp frame.
What I'm doing wrong?
Thank you