I have recently acquired a Microsemi IGM-1100i Grandmaster. Unlike my old grandmaster, a TM2000A, this one isn't plug and play and being new to PTP I'm kinda lost.
Per the user manual from the manufacturer my config is as follows:
PTP MASTER CONFIGURATION WITH PROFILE Default:
PTP State : enable
PTP Max Number Clients : 4
PTP TTL : 20
PTP DSCP : 25
PTP Dither : enable
PTP Two Steps : enable
PTP Announce Limit : 2
PTP Sync Limit : -6
PTP Delay Limit : -2
PTP Priority 1 : 200
PTP Priority 2 : 200
PTP Domain : 0
PTP Client-Timeout : 500
PTP Announce-Timeout : 4
PTP Vlan-Id : 20
PTP Timescale : AUTO
by going through the help file with ptpd the latest command that I've tried without success is:
sudo ptpd -g -C -i 0 -n 2 -b eth0
any suggestions on how I can get the ptpd settings to talk to this infernal device?
TIA,
Andrew
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi Gents,
I have recently acquired a Microsemi IGM-1100i Grandmaster. Unlike my old grandmaster, a TM2000A, this one isn't plug and play and being new to PTP I'm kinda lost.
Per the user manual from the manufacturer my config is as follows:
PTP MASTER CONFIGURATION WITH PROFILE Default:
GOt this resolved,