I am using PTPD2.3.1rc1 .its a latest version of ptp . I am working on RHEL 6.0 and 3.12.8 kernel in it. i have setup a master and slave on two pcs by ptpd2 daemon.
but i am not able to synchronize the slave with my master clock. Slave clock is always 1.5 millisecond to 500us behind the master clock.
offset from master varies a great range and never comes in sub microsecond range. I am getting delay of 1.5 milli to 600 us.How sub microsecond sync can be achieve?
What minimal PTP configuration file should i use to get the sync in microsecond range?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I am using PTPD2.3.1rc1 .its a latest version of ptp . I am working on
RHEL 6.0 and 3.12.8 kernel in it. i have setup a master and slave on
two pcs by ptpd2 daemon.
but i am not able to synchronize the slave with my master clock. Slave
clock is always 1.5 millisecond to 500us behind the master clock.
offset from master varies a great range and never comes in sub
microsecond range. I am getting delay of 1.5 milli to 600 us.How sub
microsecond sync can be achieve?
What minimal PTP configuration file should i use to get the sync in
microsecond range?
Proper synchronization depends on a lot of factors. What is the network
layout? Is this with
a crossover cable or through a hub? What configuration are you using?
Can you show
us some log output from the daemon?
Best,
George
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I am using PTPD2.3.1rc1 .its a latest version of ptp . I am working on RHEL 6.0 and 3.12.8 kernel in it. i have setup a master and slave on two pcs by ptpd2 daemon.
but i am not able to synchronize the slave with my master clock. Slave clock is always 1.5 millisecond to 500us behind the master clock.
offset from master varies a great range and never comes in sub microsecond range. I am getting delay of 1.5 milli to 600 us.How sub microsecond sync can be achieve?
What minimal PTP configuration file should i use to get the sync in microsecond range?
On 5 Feb 2015, at 14:21, devendra chouhan wrote:
Proper synchronization depends on a lot of factors. What is the network
layout? Is this with
a crossover cable or through a hub? What configuration are you using?
Can you show
us some log output from the daemon?
Best,
George