[Pcb-bugs] [ pcb-Bugs-3045398 ] rendering of pads, vias and solder mask

[SourceForge.net <no...@so...>]

Bugs item #3045398, was opened at 2010-08-15 13:45
Message generated for change (Tracker Item Submitted) made by 
You can respond by visiting: 
https://sourceforge.net/tracker/?func=detail&atid=538811&aid=3045398&group_id=73743

Please note that this message will contain a full copy of the comment thread,
including the initial issue submission, for this request,
not just the latest update.
Category: None
Group: None
Status: Open
Resolution: None
Priority: 5
Private: No
Submitted By: ameno ()
Assigned to: Nobody/Anonymous (nobody)
Summary: rendering of pads, vias and solder mask

Initial Comment:
imho the solder mask should be rendered on top of pads (and pin's annular ring). there are smd parts, that have a smaller mask clearance than pad size (i.e. part of the pad is covered by solder mask). this is not visible in pcb until you toggle pads/pins on and off while the mask layer is enabled.

also, i noticed that the vias' annular ring is not rendered, if the "solder mask hole" (as defined in the report popup window) is <=0. this can easily be reproduced by placing a single via in a new pcb, activating the mask layer and playing around with "k" and "shift+k". 

im using the gtk hid of the 2009 snapshot.

----------------------------------------------------------------------

You can respond by visiting: 
https://sourceforge.net/tracker/?func=detail&atid=538811&aid=3045398&group_id=73743