[PacketFence-users] Request for final config steps

[Nagasuki <nag...@gm...>]

Hello. I am in the process of implementing PacketFence, and my intention is
to deploy a setup that does the following:
‎
‎- User plugs into wired port
‎- 802.1X login (AD credentials)
‎- If device is not registered → forced into Registration VLAN
‎- Captive portal appears
‎- User logs in again → device registered
‎- PacketFence reauthenticates device
‎Based on AD group:
‎Staff → VLAN 251
‎Student → VLAN 253
‎- WiFi is connected on an in-line interface
‎
‎So far I have done:
‎1. Configuration of management interfaces and IP

‎2. Configured a second trunk interface and on it I specified sub-interface
IPs and VLANing for isolation and registration networks

‎3. Specified VLANs without IPs (and type 'Other' for two more VLANs that
will be normal VLANs each for staff and students

‎4. On the physical switch, I configured a trunk port going to the
PacketFence second interface, plus an access port going to the PacketFence
management network. I also configured two test access ports with 802.1x
fully configured for VLAN enforcement

‎5. In PacketFence, I joined domain and also specified base and bind DNs.
These are all confirmed to be working

‎6. I also added a test switch, created two additional roles that I intend
to map staff and students' VLANs to. On the switch (in PacketFence), I also
further configured the roles and specified VLAN IDs for registration,
isolation, staff, students, and guest

‎7. I have also associated both the default and null realms with my domain
‎
‎Please guide me step by step to configure the remaining componets for my
deployment.
‎
‎Regards,
‎Nagasuki