[Ourorgan-grandorgue-user] GrandOrgue and FCB1010

[jer <jer...@gm...>]

Hello,

I am using GO and have for a number of years. It is a superb piece of 
software with excellent choices of organs.

I have a 3 manual + 25 note pedal board running on a dedicated computer 
running Linux Mint 18.3 Mate (based on Ubuntu 16.04) with GO v 
0.3.1.2291+200. I am also using two Novation launchpad mini pads for the 
stops and general pistons. All work without any problems

I recently purchased an FCB1010 along with Rolland's UM One MIDI to USB 
cable to hook up to the computer. The FCB1010 was purchased mainly for 
the volume pedals. The problem is that the computer does not see the 
FCB1010. The pedals on the organ were midified using Artisan's input 
board along with their micro-midi board. The MIDI out of the board goes 
to the out midi cable of the Rolland UM One cable, unusual since the out 
usually is fed into the in input.

Does anyone have any suggestions as to what to do? Lars Palo, if I am 
not mistaken you used, or are using an FCB1010 with your GO 
installation. Any suggestions?

Thanking you in advance for any help that I can get.

Jerry