[openwince-list] IXDPG425 + WIGGLER

[Stewart H. <st...@he...>]

I get no response to the "detect" command in jtag 0.5.1 under linux.
The target board (Intel IXDPG425, also known as MonteJade) is powered,
and the JTAG cable is connected.
The Wiggler is connected to my parallel port
which is configured (in BIOS) for port 0x378 using Bi-Dir mode.
The kernel has parallel port support enabled.
What could I be doing wrong?
Can anybody help?

JTAG Tools 0.5.1
Copyright (C) 2002, 2003 ETC s.r.o.
JTAG Tools is free software, covered by the GNU General Public License, and 
you are
welcome to change it and/or distribute copies of it under certain conditions.
There is absolutely no warranty for JTAG Tools.

Warning: JTAG Tools may damage your hardware! Type "quit" to exit!

Type "help" for help.

jtag> cable parallel 0x378  WIGGLER
Initializing Macraigor Wiggler JTAG Cable on parallel port at 0x378
jtag> detect
jtag>                                            

# cat /proc/ioports
0000-001f : dma1
0020-003f : pic1
0040-005f : timer
0060-006f : keyboard
0070-007f : rtc
0080-008f : dma page reg
00a0-00bf : pic2
00c0-00df : dma2
00f0-00ff : fpu
01f0-01f7 : ide0
02f8-02ff : serial(set)
0378-037a : parport0
03c0-03df : vga+
03f6-03f6 : ide0
03f8-03ff : serial(set)
0cf8-0cff : PCI conf1
a000-afff : PCI Bus #01
  ac00-ac7f : PCI device 1039:6330 (Silicon Integrated Systems [SiS])
d000-d07f : Digital Equipment Corporation DECchip 21140 [FasterNet]
  d000-d07f : tulip
d400-d4ff : Silicon Integrated Systems [SiS] SiS900 10/100 Ethernet
  d400-d4ff : sis900
d800-d87f : Silicon Integrated Systems [SiS] Sound Controller
dc00-dcff : Silicon Integrated Systems [SiS] Sound Controller
ff00-ff0f : Silicon Integrated Systems [SiS] 5513 [IDE]
  ff00-ff07 : ide0
  ff08-ff0f : ide1

-- 
Stewart Heitmann <st...@he...>