Re: [Openslp-devel] Need information - Openslp with DNS

[Pravinash J <pra...@am...>]

Yes. Even though it is disabled, slpd will take default configuration.

Regards,
Pravinash
From: HIRD Matthew [mailto:Mat...@uk...]
Sent: Monday, March 9, 2015 4:09 PM
To: Pravinash J; ope...@li...
Subject: RE: Need information - Openslp with DNS

Are you saying you run with all the parameters disabled in your real system?

cheers
Matt

From: Pravinash J [mailto:pra...@am...]
Sent: 09 March 2015 10:02
To: HIRD Matthew; ope...@li...<mailto:ope...@li...>
Subject: RE: Need information - Openslp with DNS

Attached is the slp.conf. All the parameters are disabled.

Regards,
Pravinash
From: HIRD Matthew [mailto:Mat...@uk...]<mailto:[mailto:Mat...@uk...]>
Sent: Monday, March 9, 2015 3:26 PM
To: Pravinash J; ope...@li...<mailto:ope...@li...>
Subject: RE: Need information - Openslp with DNS

Can you post your slp.conf?

cheers
Matt

From: Pravinash J [mailto:pra...@am...]
Sent: 05 March 2015 12:08
To: ope...@li...<mailto:ope...@li...>
Subject: [Openslp-devel] Need information - Openslp with DNS

Dear All,

I am using slpd in embedded system. Slpd is taking two minutes to start if DNS is down.
It is starting within a second even though invalid DNS IP (IP is reachable) is configured. But if IP address is not reachable then it is taking more than 2 minutes to start.
Can you please let me know the reason? Also is it possible to start the slpd quickly with slp.conf changes when DNS is down?

Regards,
Pravinash