I've been using your programmer flawlessly and thanks for the new update
0.7.9,
If not too much I'm wishing that if you can improve the GUI particularly for
the ATMEL uC. I'm trying to program ATMega8 but can't figure out where or how
can i set the config/fuses??
Also if you can support EON EN25T80 SPI chips much better..
Hi,
you have to calculate the hex value for every config byte you need to write
and insert it in the corresponding field in the device tab (or use the
command-line option), then check the write button besides.
What is missing with the 25T80?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi albmcc,
I've been using your programmer flawlessly and thanks for the new update
0.7.9,
If not too much I'm wishing that if you can improve the GUI particularly for
the ATMEL uC. I'm trying to program ATMega8 but can't figure out where or how
can i set the config/fuses??
Also if you can support EON EN25T80 SPI chips much better..
http://www.sunnic.com.tw/upfiles/tw_file01277712143.pdf
Thanks so much for developing this project.
WBR
Ron
Hi,
you have to calculate the hex value for every config byte you need to write
and insert it in the corresponding field in the device tab (or use the
command-line option), then check the write button besides.
What is missing with the 25T80?