12F1501 Program OK...

An USB programmer for PIC, dsPIC, AVR, serial memories

Brought to you by: albmcc

12F1501 Program OK...

Forum: Open Discussion

Creator: Anonymous

Created: 2019-02-14

Updated: 2019-02-14

Anonymous - 2019-02-14

Hi.
Tested the 12F1501 with success...

1) programming OK
2) reading seems OK
3) saving the readed device memory DOES NOT seems good...

Attached files are: copy of User Interface after reading, log of reading, original .hex, readed-saved .hex and 2 dumps (for comparison purpose) of the original and the saved .hex files...

Regards,
Valter

Log.txt

op-dump.txt

op-read-UI.txt

op-read-blink.hex

xc-dump.txt

xc8_12F1501_blink.X.production.hex

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- Anonymous
  
  Add attachments
  Cancel
  You seem to have CSS turned off. Please don't fill out this field.
  
  You seem to have CSS turned off. Please don't fill out this field.

Alberto Maccioni - 2019-02-14

Same problem as:
https://sourceforge.net/p/openprogrammer/discussion/1096961/thread/4e69696ed6/
The workaround is to select a 16F device before saving.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- Anonymous
  
  Add attachments
  Cancel
  You seem to have CSS turned off. Please don't fill out this field.
  
  You seem to have CSS turned off. Please don't fill out this field.
- Anonymous - 2019-02-14
  
  Thanks, I will use this method... 16F1503 is probably the logical choice (for saving)...
  
  If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
  - Anonymous
    
    Add attachments
    Cancel
    You seem to have CSS turned off. Please don't fill out this field.
    
    You seem to have CSS turned off. Please don't fill out this field.

Anonymous