I just want to ask if the OP already support the 16F183xx family...
When I choose this chip family 18313 on the OP-GUI, there is ONLY 2 configuration words showing, instead of 4... on the Config Word box area...
Question: at the command level, OP is already supporting this family?
In this case, the OP-GUI still need to change to reflect the code?
Thanks,
Valter
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I just want to ask if the OP already support the 16F183xx family...
When I choose this chip family 18313 on the OP-GUI, there is ONLY 2 configuration words showing, instead of 4... on the Config Word box area...
Question: at the command level, OP is already supporting this family?
In this case, the OP-GUI still need to change to reflect the code?
Thanks,
Valter
The devices are supported but I did not add the possibility to force all config words.
Will do so in the next version
Thanks.
Regards,
Valter
Just want to confirm that it is working for the 16F18313.
Thanks,
Valter