Open Programmer 's a great contribution , congratulations and thanks for sharing !!
I want to build it, but I have a question about the connection of the dspic and pic 24f . There is a 10 uF capacitor connected between the VSS and VDD pin according to the dspic icsp , said capacitor is connected to VSS of module , but not to VDD . It really works unconnected or connect VDD or need that ?
Take a picture to illustrate it.
another question ...
the open programmer supports pic32 ?
Thanks again!!!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I changed the pcb to put a zif socket to make it compatible with pic 10F , 12F , 16F and 18F , I do the same with expansion boards , this is the only question that I have to do , but then would not have to go connected to 3.3v ? as in the case of Pic's LF where a jumper to connect vcore
Last edit: Anonymous 2015-04-03
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
View and moderate all "Open Discussion" comments posted by this user
Mark all as spam, and block user from posting to "Discussion"
Open Programmer 's a great contribution , congratulations and thanks for sharing !!
I want to build it, but I have a question about the connection of the dspic and pic 24f . There is a 10 uF capacitor connected between the VSS and VDD pin according to the dspic icsp , said capacitor is connected to VSS of module , but not to VDD . It really works unconnected or connect VDD or need that ?
Take a picture to illustrate it.
another question ...
the open programmer supports pic32 ?
Thanks again!!!
That capacitor is for the core voltage regulator.
VDD is decoupled on the main board.
No support for pic32 yet.
View and moderate all "Open Discussion" comments posted by this user
Mark all as spam, and block user from posting to "Discussion"
I changed the pcb to put a zif socket to make it compatible with pic 10F , 12F , 16F and 18F , I do the same with expansion boards , this is the only question that I have to do , but then would not have to go connected to 3.3v ? as in the case of Pic's LF where a jumper to connect vcore
Last edit: Anonymous 2015-04-03
Sorry, I don't get your question.
Can you explain what you need?
View and moderate all "Open Discussion" comments posted by this user
Mark all as spam, and block user from posting to "Discussion"
if the pins 14,20 and 22 to bring the image of the post 1 must be connected to vdd6 or not?
No.
If they had to be connected to VDD6 they would already be connected.