We have read through the files from Kalycito about OpenConfigurator. But no really explanation is gives to which of the PowerLink stack files should be replaced by the generated OpenConfigurator files.
Our setup is one PC MN and one PC CN, where the XDD-files for the MN and CN are taken from the PowerLink stack and implemented in OpenConfigurator.
So our question is, which files from OpenConfigurator should replace the files in the PowerLink stack?
Is it sufficient to only replace xap.h in demo_mn_console?
Regards, David
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
If you are following the Kalycito instructions for the demo, the two files that needed to be replaced are: xap.h and mnobd.cdc. If you are using windows, they are located at:
Hello.
We have read through the files from Kalycito about OpenConfigurator. But no really explanation is gives to which of the PowerLink stack files should be replaced by the generated OpenConfigurator files.
Our setup is one PC MN and one PC CN, where the XDD-files for the MN and CN are taken from the PowerLink stack and implemented in OpenConfigurator.
So our question is, which files from OpenConfigurator should replace the files in the PowerLink stack?
Is it sufficient to only replace xap.h in demo_mn_console?
Regards, David
Hi David,
If you are following the Kalycito instructions for the demo, the two files that needed to be replaced are: xap.h and mnobd.cdc. If you are using windows, they are located at:
(1) ...\openPOWERLINK_V2.5.2\apps\demo_mn_console\src
(2) ...\openPOWERLINK_V2.5.2\bin\windows\amd64\demo_mn_console
You also need to rebuild the demo_mn_console application.
Best regards,
Simon
Thanks Simon for the information.
Regards, David