I am trying to run openPOWERLINK on a virtual network composed by 3 virtual machines. The network's topology is this:
PC1, PC2 and Switch run Ubuntu 16.04.1 and the machines are correctly connected. Kernel version is 4.4.0-31-generic
I want to run demo_mn_qt on PC1 and demo_cn_console on PC2. libpcap and qt5 are installed.
I built the stack in both PC1 and PC2 using the following commands:
$ cd <openPOWERLINK_DIR>/stack/build/linux
$ cmake -DCMAKE_BUILD_TYPE=Debug ../..
$ sudo make
$ sudo make install
$ cmake -DCMAKE_BUILD_TYPE=Release ../..
$ sudo make
$ sudo make install
To build demo_mn_qt I used the following code in PC1:
$ cd <openPOWERLINK_DIR_PC1>/apps/demo_mn_qt/build/linux
$ cmake ../..
$ sudo make
$ sudo make install
To build demo_cn_console I used the following code in PC2:
$ cd <openPOWERLINK_DIR_PC2>/apps/demo_cn_console/build/linux
$ cmake ../..
$ sudo make
$ sudo make install
The Error
when I try to run demo_mn_qt on PC1 it opens the graphical window and looks it fine. But when I run demo_cn_console and select the interface number 3 (enp0s8) I get this:
I tried running the same commands and using openPOWERLINK on two mininet hosts and I could at least run the program, but on this virtual network I can't. Am I using some command wrong?
Thank you.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I am trying to run openPOWERLINK on a virtual network composed by 3 virtual machines. The network's topology is this:
PC1, PC2 and Switch run Ubuntu 16.04.1 and the machines are correctly connected. Kernel version is 4.4.0-31-generic
I want to run demo_mn_qt on PC1 and demo_cn_console on PC2. libpcap and qt5 are installed.
I built the stack in both PC1 and PC2 using the following commands:
To build demo_mn_qt I used the following code in PC1:
$ cd <openPOWERLINK_DIR_PC1>/apps/demo_mn_qt/build/linux $ cmake ../.. $ sudo make $ sudo make install
To build demo_cn_console I used the following code in PC2:
$ cd <openPOWERLINK_DIR_PC2>/apps/demo_cn_console/build/linux $ cmake ../.. $ sudo make $ sudo make install
The Error
when I try to run demo_mn_qt on PC1 it opens the graphical window and looks it fine. But when I run demo_cn_console and select the interface number 3 (enp0s8) I get this:
I tried running the same commands and using openPOWERLINK on two mininet hosts and I could at least run the program, but on this virtual network I can't. Am I using some command wrong?
Thank you.
Hi Diego,
What is the error which you are running into ?
Best Regards,
aeicoriiotteam