---
**[tickets:#411] Configuration summary doesn't list "Linux GPIO bitbang through libgpiod" when enabled**
**Status:** new
**Milestone:** 0.11.0
**Created:** Wed Aug 09, 2023 04:06 PM UTC by Tommy Murphy
**Last Updated:** Wed Aug 09, 2023 04:06 PM UTC
**Owner:** nobody
Minor issue that I just noticed today.
The first time I ran `configure` I got this:
```
OpenOCD configuration summary
--------------------------------------------------
MPSSE mode of FTDI based devices no
cJTAG (OScan1, JScan3) tunneled thru MPSSEno
ST-Link Programmer no
TI ICDI JTAG Programmer no
Keil ULINK JTAG Programmer no
Altera USB-Blaster II Compatible no
Bitbang mode of FT232R based devices no
Versaloon-Link JTAG Programmer no
TI XDS110 Debug Probe no
CMSIS-DAP v2 Compliant Debugger no
OSBDM (JTAG only) Programmer no
eStick/opendous JTAG Programmer no
Olimex ARM-JTAG-EW Programmer no
Raisonance RLink JTAG Programmer no
USBProg JTAG Programmer no
Espressif JTAG Programmer no
CMSIS-DAP Compliant Debugger no
Nu-Link Programmer no
Cypress KitProg Programmer no
Altera USB-Blaster Compatible no
ASIX Presto Adapter no
OpenJTAG Adapter no
Linux GPIO bitbang through libgpiod no
SEGGER J-Link Programmer no
Bus Pirate yes (auto)
Use Capstone disassembly framework no
```
I then ran `sudo apt install libgpiod-dev` and then re-ran `configure` and got this:
```
OpenOCD configuration summary
--------------------------------------------------
MPSSE mode of FTDI based devices no
cJTAG (OScan1, JScan3) tunneled thru MPSSEno
ST-Link Programmer no
TI ICDI JTAG Programmer no
Keil ULINK JTAG Programmer no
Altera USB-Blaster II Compatible no
Bitbang mode of FT232R based devices no
Versaloon-Link JTAG Programmer no
TI XDS110 Debug Probe no
CMSIS-DAP v2 Compliant Debugger no
OSBDM (JTAG only) Programmer no
eStick/opendous JTAG Programmer no
Olimex ARM-JTAG-EW Programmer no
Raisonance RLink JTAG Programmer no
USBProg JTAG Programmer no
Espressif JTAG Programmer no
CMSIS-DAP Compliant Debugger no
Nu-Link Programmer no
Cypress KitProg Programmer no
Altera USB-Blaster Compatible no
ASIX Presto Adapter no
OpenJTAG Adapter no
SEGGER J-Link Programmer no
Bus Pirate yes (auto)
Use Capstone disassembly framework no
```
Note that it does not list this for some reason:
```
Linux GPIO bitbang through libgpiod yes
```
---
Sent from sourceforge.net because ope...@li... is subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a mailing list, you can unsubscribe from the mailing list. |
