[Openocd-svn] r2352 - trunk/tcl/board

[<oh...@ma...>]

Author: oharboe
Date: 2009-06-22 19:32:17 +0200 (Mon, 22 Jun 2009)
New Revision: 2352

Modified:
   trunk/tcl/board/hitex_stm32-performancestick.cfg
Log:
David Brownell <da...@pa...> Make the Hitex STM32-PerformanceStick board config behave better:
source the STM32 target config instead of using a private clone

Modified: trunk/tcl/board/hitex_stm32-performancestick.cfg
===================================================================
--- trunk/tcl/board/hitex_stm32-performancestick.cfg	2009-06-22 17:31:12 UTC (rev 2351)
+++ trunk/tcl/board/hitex_stm32-performancestick.cfg	2009-06-22 17:32:17 UTC (rev 2352)
@@ -1,50 +1,9 @@
 # Hitex stm32 performance stick
 
-if { [info exists CHIPNAME] } {	
-   set  _CHIPNAME $CHIPNAME    
-} else {	 
-   set  _CHIPNAME stm32_hitex
-}
+set  CHIPNAME stm32_hitex
+source [find target/stm32.cfg]
 
-if { [info exists ENDIAN] } {	
-   set  _ENDIAN $ENDIAN    
-} else {	 
-   set  _ENDIAN little
-}
-
-# set jtag speed
-jtag_khz 500
-
-jtag_nsrst_delay 100
-jtag_ntrst_delay 100
-
-#use combined on interfaces or targets that can't set TRST/SRST separately
-reset_config trst_and_srst
-
-#jtag scan chain
-# The CPU
-if { [info exists CPUTAPID ] } {
-   set _CPUTAPID $CPUTAPID
-} else {
-  # See STM Document RM0008
-  # Section 26.6.3
-   set _CPUTAPID 0x3ba00477
-}
-jtag newtap $_CHIPNAME cpu -irlen 4 -ircapture 0x1 -irmask 0xf -expected-id $_CPUTAPID
-
-# The boundery scan register, leave the "expected-id" undefined.
-jtag newtap $_CHIPNAME bs  -irlen 5 -ircapture 0x1 -irmask 0x1 
-
 # configure str750 connected to jtag chain
+# FIXME -- source [find target/str750.cfg] after cleaning that up
 jtag newtap $_CHIPNAME unknown -irlen 4 -ircapture 0x1 -irmask 0x0f
 
-set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
-target create $_TARGETNAME cortex_m3 -endian $_ENDIAN -chain-position $_TARGETNAME
-
-$_TARGETNAME configure -work-area-virt 0 -work-area-phys 0x20000000 -work-area-size 16384 -work-area-backup 0
-
-#
-flash bank stm32x 0 0 0 0 0
-
-# For more information about the configuration files, take a look at:
-# openocd.texi