|
From: <oh...@ma...> - 2009-01-05 10:25:28
|
Author: oharboe
Date: 2009-01-05 10:25:23 +0100 (Mon, 05 Jan 2009)
New Revision: 1299
Added:
trunk/src/target/board/x300t.cfg
trunk/src/target/interface/parport_dlc5.cfg
trunk/src/target/target/smp8634.cfg
Log:
Andi <ope...@gm...> basic support for the MIPS based SMP8634 SoC.
Added: trunk/src/target/board/x300t.cfg
===================================================================
--- trunk/src/target/board/x300t.cfg 2009-01-04 08:51:48 UTC (rev 1298)
+++ trunk/src/target/board/x300t.cfg 2009-01-05 09:25:23 UTC (rev 1299)
@@ -0,0 +1,17 @@
+# This is for the T-Home X300T / X301T IPTV box,
+# which are based on IPTV reference designs from Kiss/Cisco KMM-32**
+#
+# It has Sigma Designs SMP8634 chip.
+source [find target/smp8634.cfg]
+
+$_TARGETNAME configure -event reset-init { x300t_init }
+
+# 1MB CFI capable flash
+# flash bank <driver> <base> <size> <chip_width> <bus_width>
+flash bank cfi 0xac000000 0x100000 2 2 0
+
+proc x300t_init { } {
+ # Setup SDRAM config and flash mapping
+ # map flash to CPU address space REG_BASE_cpu_block+CPU_remap4
+ mww 0x6f010 0x48000000
+}
Added: trunk/src/target/interface/parport_dlc5.cfg
===================================================================
--- trunk/src/target/interface/parport_dlc5.cfg 2009-01-04 08:51:48 UTC (rev 1298)
+++ trunk/src/target/interface/parport_dlc5.cfg 2009-01-05 09:25:23 UTC (rev 1299)
@@ -0,0 +1,7 @@
+telnet_port 4444
+gdb_port 2001
+
+interface parport
+parport_port /dev/parport0
+parport_cable dlc5
+jtag_speed 0
Added: trunk/src/target/target/smp8634.cfg
===================================================================
--- trunk/src/target/target/smp8634.cfg 2009-01-04 08:51:48 UTC (rev 1298)
+++ trunk/src/target/target/smp8634.cfg 2009-01-05 09:25:23 UTC (rev 1299)
@@ -0,0 +1,32 @@
+# script for Sigma Designs SMP8634 (eventually even SMP8635)
+
+if { [info exists CHIPNAME] } {
+ set _CHIPNAME $CHIPNAME
+} else {
+ set _CHIPNAME smp8634
+}
+
+if { [info exists ENDIAN] } {
+ set _ENDIAN $ENDIAN
+} else {
+ set _ENDIAN little
+}
+
+if { [info exists CPUTAPID ] } {
+ set _CPUTAPID $CPUTAPID
+} else {
+ # force an error till we get a good number
+ set _CPUTAPID 0x08630001
+}
+
+jtag_nsrst_delay 100
+jtag_ntrst_delay 100
+
+reset_config trst_and_srst separate
+
+# jtag scan chain
+# format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE)
+jtag newtap $_CHIPNAME cpu -irlen 5 -ircapture 0x1 -irmask 0x1
+
+set _TARGETNAME [format "%s.cpu" $_CHIPNAME]
+target create $_TARGETNAME mips_m4k -endian $_ENDIAN -variant
|