Re: [Openocd-development] AVR32 support

[simon q. <sim...@gm...>]

It should be same for UC3C series, because the port is 5V tolarent.
I'm using KiCAD, eagle has a limitation on the size of the PCB.

I have released the AVR32 code, but it will be tested later this week.
http://code.google.com/p/vsprog/source/browse/trunk/dongle/firmware/STK500v2
http://code.google.com/p/vsprog/source/browse/trunk/dongle/firmware/STK500v2/Target/AVR32_JTAG
2010/9/1 Michel Catudal <mic...@gm...>

> On 31/08/2010 11:18, simon qian wrote:
>
>> My AVR32 debugger/programmer will be released next week.
>> I'll get some sample(UC3B0256) from Atmel this week.
>> I think I can do the test after next week.
>>
>>
>>
> Are you planning to support the UC3Cxxxx series as well?
> They are +5V devices and not +3.3V devices as is the UC3B0256
>
>
>
> Michel
>
> --
> Tired of Microsoft's rebootive multitasking?
> then it's time to upgrade to Linux.
> http://home.comcast.net/~mcatudal
>
>


-- 
Best Regards, SimonQian
http://www.SimonQian.com