[Openocd-development] OpenOCD and PowerPC processors

[Jon S. <jon...@gm...>]

What is needed to get OpenOCD working on a PowerPC processor like the
MPC5200? The COP connector can be electrically plugged into a 20-pin
ARM JTAG device if the pins are rearranged.

What info is needed about the processor to get gdb running?

We're doing an open source, embedded design based on the MPC5200 and
I'd like to get OpenOCD running on it to provide a low cost debugging
solution for students/hobbyists. If I know what doc is needed I can
work on getting it out of Freescale. We can also put an ARM pinout
JTAG connector on our board instead of COP.

Kurobox is based on the MPC8241 which is the same core as the MPC5200.
Various postings make me think OpenOCD is already running on the 603
PowerPC core.

-- 
Jon Smirl
jon...@gm...