#234 Mesh motion of a dynamic mesh simuation is not being updated when writing the moving patch to vtk

[Eelco van Vliet]

When running a case with a dynamical mesh motion and the moving wall is saved to vtk file using the patch typed surface, the mesh which is written to the time directories is not updated. In the openfoam simulation itself it can be seen that the mesh is updated, but this update is apparently not seen by swak4foam

An example case of a constant moving cylinder (2d) is added to demonstrate the problem.

The case was run with foam-extended-3.2, the solver was interDyFoam. The swak version was the one which comes with the foam-extended release.

The same problem occurs with a floatingBody dynamic mesh simulation

Regards
Eelco