[opencbm-user] possible bug
Brought to you by:
strik
|
From: Daryl K. <wad...@ho...> - 2024-12-10 01:45:40
|
When using ZoomFloppy, I encounter the following issue.
After using RPM1541 to check/adjust drive speed, I cannot do anything else with the Zoomfloppy unless I either unplug and replug the USB, or issue the command 'cbmctrl status {device#}' three times.
The first time I get the error "99, Driver Error ,00 ,00"
Second time I get the error "unknown status value 55"
The third time, the drive resets and then I can use the device again.
I use Ctrl-C to exit RPM1541 since I don't know any other way to exit that program. I feel that this may be improperly terminating the program and not allowing it to issue the proper reset signal? However, this has only start to happen when using ZoomFloppy. My previous XMP-1541 cable never had this issue.
When I run RPM1541 after exiting, and the run it again, I get this error (hopefully to help find where the issue is)
"USB error in xum1541_wait_status: LIBUSB_SUCCESS / LIBUSB_TRANSFER_COMPLETED"
I'm using a 1541 with a parallel cable when this happens. It also happens using a 1571 without a parallel cable.
Thanks.
[https://s-install.avcdn.net/ipm/preview/icons/icon-envelope-tick-green-avg-v1.png]<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail> Virus-free.www.avg.com<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail>
|