[Nfdump-discuss] RE : incoming / outgoing interfaces not recorded in NFDUMP

[AB S <ab_...@ya...>]

Hi all.finally i find the answer.
  1- we had Catalyst 6500 series with MSFC2/PFC2 and the netflow export config differ from software-base router.if you want the SRC/DST interfaces records on exported netflow packets , run these command on global configuration mode :
   
  Router-Odd(config)#mls nde interface
  Router-Odd(config)#mls flow ip interface-full
   
  this cause the switch add interface number to exported netflow data.but note the interface addresses are not the traditional interfaces naming on cisco devices (like serial 0/0 , fastehtethernet 3/1 or Vlan18) , else it use the SNMP ifindex schema for exported flow.
  to see the snmp ifindex with corresponded traditional interface numbering , run this command on privileges exec mode 
  Router-Odd#show  snmp mib ifmib ifindex 
  GigabitEthernet9/4: Ifindex = 104
GigabitEthernet9/5: Ifindex = 105
GigabitEthernet9/6: Ifindex = 106
.
  .
  .
  Best Regards

       
---------------------------------
Looking for a deal? Find great prices on flights and hotels with Yahoo! FareChase.