Re: [Netdisco] Fujitsu XG2000 10GB switches and other questions

[Ingen S. J. v. (ICTS) <j.v...@ut...>]

On Wed, 2010-12-22 at 20:39 -0800, Matthew Bellizzi wrote:
> Anyone have any luck getting these switches to work with Netdisco?
> Netdisco can see the port status (i.e. up/down)  but,  it's not seeing
> the node MACs.   I'm away from work ATM moment so I'll post debug from
> a macsuck  tomorrow.  The Fujitsu's do not support CDP  so I setup a
> manual topology  which leads me to my next question.  The Fujitsu has

Could you post the debug output? I don't have access to any Fujitsu gear
but perhaps the debug will give some details as to what goes wrong.

>  20 10GB ports and a management 10/100 port. Unfortunately the network
> I inherited does not have a dedicated management LAN.   So both the
> 10GB ports and the management LAN are in the same IP address space.
> Whats the proper way to reflect this in the topo file? 

If the device is managed using the mgmt LAN, I guess the best way would
be to use the IP address of that port for all entries in the topo file.
So both for the link between mgmt port and the switch it's connected to,
and for the links between 10GbE ports and other switches.

... and then see what Netdisco does with it :)


Regards,

Jeroen van Ingen
ICT Service Centre
University of Twente, P.O.Box 217, 7500 AE Enschede, The Netherlands