[Ndiswrapper-general] Problems with Belking 54G card

[Patrick v. Z. <pa...@va...>]

Hi All,

I have some problems loading the driver for my belking 54G card.
It's broadcom based, full string:
---
15:00.0 Network controller: Broadcom Corporation: Unknown device 4320 (rev
03)
        Subsystem: Belkin: Unknown device 7010
        Flags: bus master, fast devsel, latency 168, IRQ 11
        Memory at 11000000 (32-bit, non-prefetchable) [size=8K]
---

The driver bcmwl5 loads correctly for this device and the card gets
powered up. However i cannot send the essid of the card and iwconfig shows
up data that i think is weird.
Ouput iwconfig: (key X'ed out)
---
wlan0     IEEE 802.11g  ESSID:""
          Mode:Managed  Frequency:2.462GHz  Access Point: FF:FF:FF:FF:FF:FF
          Bit Rate:54Mb/s   Tx-Power:16 dBm
          RTS thr:2347 B   Fragment thr:2346 B
          Encryption key:XXXX-XXXX-XX   Security mode:restricted
          Power Management max timeout:0us  mode:All packets received
          Link Quality:100/0  Signal level:-10 dBm  Noise level:-256 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:2   Missed beacon:0
---
i'm not able to set the essid, it stays blank. iwconfig wlan0 essid
myessid will make me wait 2 secs without doing anything.

When ignoring these facts and setting up the device with ifconfig a ping
results in this kernel message (debug enabled in ndiswrapper)
---
NdisMSendComplete 00000000
send_packets returning 00000103
---

What could be wrong ?
Used the cvs version with debugging enabled.

Patrick

-- 
Life's short, the world is wide