[Ndiswrapper-general] install.sh - lspci output report

[<ris...@su...>]

Hi,

install.sh outputs following kind of message when it's run:

[root@localhost ndiswrapper]# sh install.sh
Can't find any 802.11 cards; report output of lspci
Aborting due to above errors; fix them and run this script again.

lspci dump:

[root@localhost ndiswrapper]# lspci
00:00.0 Host bridge: Intel Corp. 82852/855GM Chipset Host Bridge (rev 02)
00:00.1 System peripheral: Intel Corp.: Unknown device 3584 (rev 02)
00:00.3 System peripheral: Intel Corp.: Unknown device 3585 (rev 02)

--CLIP--

01:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5705M Gigabit
Ethernet (rev 01)
01:01.0 CardBus bridge: Texas Instruments: Unknown device ac47 (rev 01)
01:01.1 CardBus bridge: Texas Instruments: Unknown device ac4a (rev 01)
01:01.2 FireWire (IEEE 1394): Texas Instruments: Unknown device 802b
01:01.3 System peripheral: Texas Instruments: Unknown device 8204
01:03.0 Network controller: Broadcom Corporation: Unknown device 4324 (rev
02)

The WLAN-card is the last one. However it does not report itself as 802.11
-card.

I'm also experiencing compile problems (wrapper.c) just as Stefan Lüthje.

I'm using Dell Latitude D400, RH 9 and 2.4.20 kernel. Ndiswrapper was downloaded
from CVS an hour ago.


Yours,

Risto

PS 
Is there a way to view the messages sent to the list in December? The archive
only shows messages from November.


_______________________________________________________________________
Parhaat hakupalvelut yhdessä osoitteessa: http://www.eniro.fi/

Suomalaisten yritysten tuotteet ja palvelut: http://yritykset.eniro.fi/