[Ndiswrapper-general] ndiswrapper, LEAP, TKIP and Dell Wireless 1450 (BCM4309)

[Sandro P. <sp...@gm...>]

Hi,

I' trying to get my Dell Wireless 1450 mini-PCI connected to a Cisco AP
using
LEAP and TKIP with Fedora Core 3 and kernel 2.6.11-1.14_FC3.

The 1450 is found and the drivers install properly:

lspci:
02:03.0 Network controller: Broadcom Corporation BCM4309 802.11a/b/g (rev
03)
02:03.0 Class 0280: 14e4:4324 (rev 03)

modprobe ndiswrapper:
kernel: ndiswrapper version 1.1 loaded (preempt=no,smp=no)
kernel: ndiswrapper: driver bcmwl5a (Broadcom,11/27/2004, 3.100.35.0) loaded
kernel: ACPI: PCI interrupt 0000:02:03.0[A] -> GSI 5 (level, low) -> IRQ 5
kernel: ndiswrapper: using irq 5
kernel: wlan0: ndiswrapper ethernet device 00:11:f5:33:08:eb using driver
bcmwl5a, configuration file 14E4:4324.5.conf
kernel: wlan0: encryption modes supported: WEP, WPA with TKIP, WPA with
AES/CCMP

The authentication is done via Cisco ACS.

iwlist wlan0 scan finds the AP but I'm unable to associate.

I've tried wpa_supplicant as well as xsupplicant without luck.

The wpa_supplicant's config looks like this:
ctrl_interface=/var/run/wpa_supplicant # for wpa_cli support

network={
	ssid="ssid"
	scan_ssid=0
	key_mgmt=WPA-EAP
	group=TKIP
	eap=LEAP
	auth_alg=LEAP OPEN SHARED
	pairwise=TKIP
	identity="userid"
	password="password"
}

eapol_version=1
ap_scan=2

This results in:

# wpa_supplicant -iwlan0 -Dndiswrapper -c/etc/wpa_supplicant.conf -dd

---- snip ----
Initializing interface 'wlan0' conf '/etc/wpa_supplicant.conf' driver
'ndiswrapper'
Configuration file '/etc/wpa_supplicant.conf' -> '/etc/wpa_supplicant.conf'
Reading configuration file '/etc/wpa_supplicant.conf'
ctrl_interface='/var/run/wpa_supplicant'
Line: 3 - start of a new network block
ssid - hexdump_ascii(len=11):
     [REMOVED]
scan_ssid=0 (0x0)
key_mgmt: 0x1
group: 0x8
eap methods - hexdump(len=2): 11 00
auth_alg: 0x7
pairwise: 0x8
identity - hexdump_ascii(len=8):
     [REMOVED]
password - hexdump_ascii(len=8): [REMOVED]
eapol_version=1
ap_scan=2
Priority group 0
   id=0 ssid=[REMOVED]
Initializing interface (2) 'wlan0'
EAPOL: SUPP_PAE entering state DISCONNECTED
EAPOL: KEY_RX entering state NO_KEY_RECEIVE
EAPOL: SUPP_BE entering state INITIALIZE
EAP: EAP entering state DISABLED
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
ioctl[SIOCSIWPMKSA]: No such device
Own MAC address: 00:11:f5:33:08:eb
Setting scan request: 0 sec 100000 usec
Wireless event: cmd=0x8b06 len=8
Trying to associate with SSID [REMOVED]
Cancelling scan request
Automatic auth_alg selection: 0x1
Overriding auth_alg selection: 0x7
WPA: Set cipher suites based on configuration
WPA: Selected cipher suites: group 8 pairwise 8 key_mgmt 1
WPA: using GTK TKIP
WPA: using PTK TKIP
WPA: using KEY_MGMT 802.1X
WPA: Own WPA IE - hexdump(len=22): [REMOVED]
No keys have been configured - skip key clearing
State: DISCONNECTED -> ASSOCIATING
Setting authentication timeout: 5 sec 0 usec
EAPOL: External notification - portControl=Auto
Authentication with 00:00:00:00:00:00 timed out.
Added BSSID 00:00:00:00:00:00 into blacklist
State: ASSOCIATING -> DISCONNECTED
No keys have been configured - skip key clearing
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
Setting scan request: 0 sec 0 usec
Trying to associate with SSID [REMOVED]
Cancelling scan request
Automatic auth_alg selection: 0x1
Overriding auth_alg selection: 0x7
WPA: Set cipher suites based on configuration
WPA: Selected cipher suites: group 8 pairwise 8 key_mgmt 1
WPA: using GTK TKIP
WPA: using PTK TKIP
WPA: using KEY_MGMT 802.1X
WPA: Own WPA IE - hexdump(len=22): [REMOVED]
No keys have been configured - skip key clearing
State: DISCONNECTED -> ASSOCIATING
Setting authentication timeout: 5 sec 0 usec
EAPOL: External notification - portControl=Auto
CTRL-EVENT-TERMINATING - signal 2 received
State: ASSOCIATING -> DISCONNECTED
No keys have been configured - skip key clearing
EAPOL: External notification - portEnabled=0
EAPOL: External notification - portValid=0
Removed BSSID 00:00:00:00:00:00 from blacklist (clear)

---- snip ----

Anyone here having a running config or could shed some light into my issue?

Thank you,
Sandro

-- 
Weitersagen: GMX DSL-Flatrates mit Tempo-Garantie!
Ab 4,99 Euro/Monat: http://www.gmx.net/de/go/dsl