NAPS2 is a very simple way of scanning, I love all the features that's why we are including it in our project of building a book scanner. This book scanner has two scanners and a drive system that carries the book over the scanner inspired by the google engineer project of linear book scanner. I want to start the scanning process based on the value of sensor. Lets say if the sensor A is on then it should start scanning choosing scanner A. After certain time delay if sensor B is on then it should start scanning choosing scanner B. We will be reading the sensor value using serial port. I am not sure if it is possible to do using NAPS2 . What is the best way to start? Any suggestion, direction or advice would be greatly appreciated.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
NAPS2 is a very simple way of scanning, I love all the features that's why we are including it in our project of building a book scanner. This book scanner has two scanners and a drive system that carries the book over the scanner inspired by the google engineer project of linear book scanner. I want to start the scanning process based on the value of sensor. Lets say if the sensor A is on then it should start scanning choosing scanner A. After certain time delay if sensor B is on then it should start scanning choosing scanner B. We will be reading the sensor value using serial port. I am not sure if it is possible to do using NAPS2 . What is the best way to start? Any suggestion, direction or advice would be greatly appreciated.