Re: [myhdl-list] Calling VHDL modules within MyHDL?

[Christopher L. F. <cf...@uc...>]

MyHDL supports co-simulation with Verilog and VHDL.  Currently the 
Verilog co-simulation uses the PLI/VPI interface.  Icarus and Cver are 
supported with the downloaded code.

More information can be found in the MyHDL manual.

Jan can comment on this topic better than I.

Blubaugh, David A. wrote:
> Chris,
> 
> 
> Is there a way to call or import modules in VHDL or Verilog into MyHDL?  
> If that can be done, I believe, I can call or import a VHDL module from 
> OPENCORES.org which handles the necessary floating-point multiplication, 
> subtraction, addition, and especially division.  Does anyone believe 
> that this is feasible??
> 
> 
> Thanks,
> 
> 
> David Blubaugh
> 
> 
> 
> 
> This e-mail transmission contains information that is confidential and 
> may be privileged. It is intended only for the addressee(s) named above. 
> If you receive this e-mail in error, please do not read, copy or 
> disseminate it in any manner. If you are not the intended recipient, any 
> disclosure, copying, distribution or use of the contents of this 
> information is prohibited. Please reply to the message immediately by 
> informing the sender that the message was misdirected. After replying, 
> please erase it from your computer system. Your assistance in correcting 
> this error is appreciated.
> 
> 
> ------------------------------------------------------------------------
> 
> -------------------------------------------------------------------------
> Check out the new SourceForge.net Marketplace.
> It's the best place to buy or sell services for
> just about anything Open Source.
> http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
> 
> 
> ------------------------------------------------------------------------
> 
> _______________________________________________
> myhdl-list mailing list
> myh...@li...
> https://lists.sourceforge.net/lists/listinfo/myhdl-list