From: Robert R. <rob...@co...> - 2007-07-05 21:38:03
|
Hi, I have motion 3.2.7 running under Debian sarge. I have bttv1: detected: Provideo PV143A [card=105], PCI subsystem ID is aa00:1430 4 input 1 bt878 video card and have round robin through 4 inputs. But frequently (every few seconds) I have major change in brightness and also it travels around for a pixel or two. I've tried with autobrightness on and off, no go... How can I workaround that problem ? Is round robin going too fast selecting inputs ? Thanks in advance, regards, Rob. I have following configuration files : *********************** /etc/motion.conf norm 0 frequency 0 rotate 0 width 320 height 240 framerate 10 auto_brightness on brightness 128 contrast 128 saturation 128 hue 128 despeckle EedDl lightswitch 50 minimum_motion_frames 5 night_compensate on noise_tune on threshold_tune on smart_mask_speed 5 gap 5 post_capture 5 pre_capture 3 locate on text_double on webcam_quality 70 webcam_maxrate 5 text_changes on text_right %d-%m-%Y\n%T ffmpeg_cap_new on ffmpeg_timelapse 60 ffmpeg_timelapse_mode daily ffmpeg_video_codec msmpeg4 snapshot_interval 60 snapshot_filename %Y/%m/%d/%H/%M_%S jpeg_filename %Y/%m/%d/%H/%M_%S ffmpeg_filename movies/%d_%m_%Y_%H_%M_%S timelapse_filename %Y/%m/%d-timelapse thread /etc/motion/thread0.conf thread /etc/motion/thread2.conf thread /etc/motion/thread3.conf thread /etc/motion/thread4.conf thread /etc/motion/thread5.conf thread /etc/motion/thread6.conf *********************** /etc/motion/thread5.conf videodevice /dev/video1 input 3 noise_level 32 text_left Input3\nBad_Room target_dir /home/cameras/42 # webcam server settings webcam_port 8005 webcam_localhost off webcam_motion on # sending pluto tripped on/off events on motion start/end on_event_start /usr/pluto/bin/MessageSend 127.0.0.1 42 -1001 2 9 25 1 on_event_end /usr/pluto/bin/MessageSend 127.0.0.1 42 -1001 2 9 25 0 # custom settings from Pluto's device parameter #59 Configuration auto_brightness off |